Skip to content

Latest commit

 

History

History
43 lines (29 loc) · 1.31 KB

README-flash-uefi.md

File metadata and controls

43 lines (29 loc) · 1.31 KB
Raw

Setup Console

  • Install ser2net. Use telnet as the console since UEFI will output window that fails to display in minicom.
    $sudo apt-get install ser2net

  • Configure ser2net.
    $sudo vi /etc/ser2net.conf

    Append one line for serial-over-USB in below.

    #ser2net.conf

    2004:telnet:0:/dev/ttyUSB0:115200 8DATABITS NONE 1STOPBIT banner

  • Open the console.
    $telnet localhost 2004

    And you could open the console remotely, too.

    OR USE picocom

  • Install picocom. Use picocom as the console since UEFI will output window that fails to display in minicom.
    $sudo apt-get install picocom

  • Open the console.
    $picocom /dev/ttyUSB0 -b 115200 -f x

  1. Connect the HiKey960 and prepare for flash assuming the host machine already has adb and fastboot installed a. On the Hikey960

...Set switch 1 and 2 to on and 3 to off

...Connect the uart to the host system and make sure it shows up as ttyUSB0 using dmesg command

...Power on the HiKey960

...Connect the usb-c otg to host system and make sure that shows up as ttyUSB1

  1. sudo ./recovery-flash-uefi-prebuilt.sh -h

  2. Set switch 1 to on and 2 & 3 to off

  3. Reboot and proceed to install OS.