-
Notifications
You must be signed in to change notification settings - Fork 0
Home
Spopi can only work on Raspberry Pi 2 and 3
Download last Raspbian Jessie img here
Then you can insert the µSD card in the Raspberry Pi 2
sudo raspi-config => International option and change keyboard layout if needed. Default is english => expand filesystem
Then you can reboot the Raspberry
To set DHCP on the network interface
Replace in /dev/network/interface/
iface eth0 inet manual
by
iface eth0 inet dhcp
If you want static IP address, you have to replace in /dev/network/interface/
iface eth0 inet manual
by
auto eth0
iface eth0 inet static
address 192.168.2.16
netmask 255.255.255.0
gateway 192.168.2.1
dns-nameservers 192.168.2.1
And then relaunch the network with
sudo service networking restart
Now you can test the network:
ping www.ipgp.fr
wget -O /tmp/spopi_install.bash https://raw.githubusercontent.com/IPGP/Spopi/master/spopi_install.bash
or
wget -O /tmp/spopi_install.bash https://goo.gl/bEwmmC
bash /tmp/spopi_install.bash
It last between 10 and 20 minutes. At the end, you just have to reboot and enjoy !
sudo reboot
They are two simple example of Spopi usage in /home/pi/visu:
2/3 of the screen with a drum plot and 1/3 of the screen with a line plot
half of the screen with a station, the other half with another one
3 line-plot stations
You can modify them and choose which of those programms will start at the end of /home/pi/visu/screen_on.bash
Visualisation will start at boot and crons are also installed. You can change start and end of visualisation by editing the crontab:
crontab -e
You can either connect to the Raspberry with ssh (user is pi and default password is raspberry) or change tty