motor-on-roller-blind-ws

This one is a fork of Peter's original WebSocket version. This version got additional support for a physical switch to move the blinds.

Otherwise it's the WebSocket based version of motor-on-roller-blind. I.e. there is no need of an MQTT server but MQTT is supported as well - you can control it with WebSockets and/or with MQTT messages.

Revised 3d parts for printing are available on Thingiverse.com: "motor on a roller blind"

1. A tiny webserver is setup on the esp8266 that will serve one page to the client
2. Upon powering on the first time WIFI credentials, a hostname and - optional - MQTT server details is to be configured. You can specify if you want clockwise (CW) rotation to close the blind and you can also specify MQTT authentication if required. Connect your computer to a new WIFI hotspot named BlindsConnectAP. Password = nidayand
3. Connect to your normal WIFI with your client and go to the IP address of the device - or if you have an mDNS supported device (e.g. iOS, OSX or have Bonjour installed) you can go to http://{hostname}.local. If you don't know the IP-address of the device check your router for the leases (or check the serial console in the Arduino IDE or check the /raw/esp8266/register MQTT message if you are using an MQTT server)
4. As the webpage is loaded it will connect through a websocket directly to the device to progress updates and to control the device. If any other client connects the updates will be in sync.
5. Go to the Settings page to calibrate the motor with the start and end positions of the roller blind. Follow the instructions on the page

MQTT

• When it connects to WIFI and MQTT it will send a "register" message to topic /raw/esp8266/register with a payload containing chip-id and IP-address
• A message to /raw/esp8266/[chip-id]/in will steer the blind according to the "payload actions" below
• Updates from the device will be sent to topic /raw/esp8266/[chip-id]/out

If you don't want to use MQTT

Simply do not enter any string in the MQTT server form field upon WIFI configuration of the device (step 3 above)

Payload options

• (start) - (calibrate) Sets the current position as top position
• (max) - (calibrate) Sets the current position as max position. Set start before you define max as max is a relative position to start
• (0) - (manual mode) Will stop the curtain
• (-1) - (manual mode) Will open the curtain. Requires (0) to stop the motor
• (1)- (manual mode) Will close the curtain. Requires (0) to stop the motor
• 0-100 - (auto mode) A number between 0-100 to set % of opened blind. Requires calibration before use. E.g. 50 will open it to 50%

Required libraries (3rd party)

• AccelStepper: http://www.airspayce.com/mikem/arduino/AccelStepper/
• PubSubClient: https://github.com/knolleary/pubsubclient/
• ArduinoJson: https://github.com/bblanchon/ArduinoJson
• WIFIManager: https://github.com/tzapu/WiFiManager
• WbSocketsServer: https://github.com/Links2004/arduinoWebSockets

Screenshots

Control

Calibrate

Communication settings